Hi everyone,

I'm always amazed at the diversity among all of the MV users and was wondering what everyone is doing for aggregates out there.

We have a nested based Weeke Vantage 200 (5x12 Table) and have always ran a Benz Duo with a miterfold cutter attached. Our team is looking for a backup aggregate and have been looking at their moulder aggregate so we can put the cutter directly under the spindle instead of off to one side. 

They say that it will fit and work, but we are wondering if anyone out there is using one and how they are programming it. We currently run our aggregate as a saw in MV, but from what I've seen in output through Woodwop we can only have straight lines. 

Thanks, 

Matt