In my nest I usually have to move some of our smaller part into the center of the sheets, i also need to change the setmill locations on any of our smaller parts to ensure they don't move during machining. That all works fine but since we updated our software i have been getting a warning message that says "The Lead-in/or Lead-out generated at the selected setmill position intersect the part boundary. Proceeding may result in invalid toolpath geometry. Do you want the setmill to this location?" However i have verified over and over that there is no issue with where it is at. But having to click yes every time greatly increases the time it takes when modifying the nests. This message pops up totally randomly as well. Doesn't seem like there is a rhyme or reason when it pops up. Is there a way to stop this message from popping up? Maybe a spot where i can click to say don't show message again? Any ideas on how to get this message to stop popping up would be great! Ive attached a screenshot of the message so you can see it.