Does anyone else out there use a Holzher point to point CNC with Microvellum? We just replaced our old easy master with a promaster and are having a few issues with the Microvellum files being sent to it. 

1) Barcode scanner is scanning parts, but will not designate them to a specific side.

2) We have ours set up in metric and we were wondering if anyone was able to successfully set it up using imperial.

We also have some minor changes we would like to make, but if someone is out there with some Holzher machines I would love to pick your brain about these issues. 

I am quite new to Microvellum, but I am eager to learn. Any help would be much appreciated. 

Thank you,

Chris Dayhoff