Microvellum Community

Mangled Elevation

I haven't been able to figure out how the products behave in 2D despite best effort to use the toolbox move vs briscad command along with association to wall. 2D drawing is a mess after a redraw and has to be moved back in place each after a "re-draw". This is a huge time suck.  

Below, I re-number the products and after a re-draw, elements like appliance, kicks, fillers are way off.  Cabinets and shelves tend to be quite reliable. 

To be fair, I do insert some elements using "Place at selected point", move them in place and then associate them to the wall such as an appliance.  But others like kicks i use place on wall immediate and still get it wrong somehow.