Hi,

We just transferred MV from an old workstation to a new one, and prior to this I did not receive this message.

When I draw products, I am receiving two popup messages stating:

The router named '3_8COMPRAMP' does not have a valid diameter. Make sure a diameter has been entered and that the tool type is 3.

The router named '1_4DOWN' does not have a valid diameter. Make sure a diameter has been entered and that the tool type is 3.

I have attached two screenshots showing these.

Does anybody know what is causing this and where I can go to resolve it? I am guessing that it might be my toolfile... 

Thank you,

Jake