The last time I was asked to build a cabinet with a beveled edge finger pull detail was well before I became a MV user. It has come up again and highlighted a hole in my ability as a user. I'm hoping someone can point me towards a knowledge base article or perhaps share a description of the work flow needed to get this type of cabinet detailed in MV. I am attaching a photo of a cabinet that has a similar detail for reference. I need to have about a 1" space between finished faces, a beveled edge on the top edge of finished faces, and what I might call a "finished vertical stretcher" that fills the space between faces. I could figure out how to achieve this part by part in a very slow and manual way, but I'm hoping MV has a way to essentially turn this construction method on at a project level. 

Any help is greatly appreciated.