Hi all, 

i've had the factory request i Nest doors with a product where we have the carcass come from the same material as the doors, but have them drilled after going through the edge bander. 

i map my parts to the factories request for our planners to run, is there a way i can force Face6 routing for doors (nest only, would just cut the door to size) then have face 5 come through with my second Parts group (this would have my hinge drilling + any other face 5 machining) 

if there is no feature to allow this i will just create a dummy part to cut in parts group 1 and have the actual part run on my point to point.

Thanks if anyone knows!