This document lists the full range of extruded products and fixtures available in Microvellum's Foundation Library. Extruded products are products that drawn or extruded along a 2D polyline path, allowing for the creation of products in a wide ...
Modify Products Tab Part Properties See the Part Properties section within the Knowledge Network. Edit Multiple Product Prompts See How to Modify Multiple Products using Edit Multiple Product Prompts. Replace Products See Using the Replace Products ...
Solid Modeling Tools - Custom Products Before using the Custom Product Builder, it is important to determine which type of custom product you will be building. There are five options to select from: Custom Product Starter – This option allows you to ...
Replace Products Using the Replace Product command allows you to replace a product currently in the drawing with another product from the product library. After selecting the product in the drawing you would like to replace, a window will be ...
Group Products Command Using the "Group Products" command allows you to save multiple products together that you can then add to other projects. The command will remember how the products were positioned and draw them back the same way. Any prompt ...
The following release notes apply to Toolbox build 24.1.1206.641 MV Server Nesting Fix There was a reported issue occurring when users attempted to remotely process work orders using a nesting station on MV Server. When attempting to process the work ...
The following release notes apply to Microvellum Foundation Library build 24.1127. Additions Added a new Soffit product to the Upper Cabinet Accessories category. Added the Top Filler (Ceiling Scribe) option to Upper and Tall cabinets. (Corner ...
The following release notes apply to Toolbox build 24.1.1125.641. IRIB Setmill Location Fix Fig. 1: Setmill being moved to the start of the route (top) rather than at the center of a straight line, as intended (bottom). There was an issue reportedly ...
The following release notes apply to Toolbox build 24.1.1105.641 Nesting Fix Fig. 1: The fatal error that would occur during processing. There was reportedly an issue that occurred when clients attempted to process a work order using the nesting ...
The following release notes apply to Microvellum Foundation Library build 24.1025. Additions Added new global variable “Remove Stop Dado On Bottom Edge” for wood drawer boxes. Check this option to run the dado through at the bottom of the sub front ...