I can't seem to change my finish label on my generated 2D elevations. They are showing as "Imperial" which is the Spec group I'm in, which is not even what was supposed to be there to begin with, I don't think (should've been L1 till I changed it to PL1). I've checked in the Project Wizard, the appropriate Lookup Tables in the workbooks, the drawing tokens, etc. The only drawing token I can find on any of the finished faces is a 3d token. All of the 2D Elevation slots are blank, but it's obviously pulling some kind of data from somewhere I haven't found. This is in the Foundation Library.