Hatch polyline settings

Hatch polyline settings

I want to do a pocket route  in some lettering we are cutting out on our CNC and I can't seem to be able to change any settings for the hatch polyline, I would like it tighter than the automatic offset that MV is giving me. Is there a way to change that offset? Also is there a way to set that up as a continuous path instead of being broken up into multiple paths, it quite obvious where the bit goes up and down; we are cutting on Corian.

    MVU eLearning



    Are You Ready to Streamline the Way You Learn?
    Follow along with RJ as he takes you on a journey to build your foundational knowledge of Toolbox.


      Follow us on: