Reports

Reports

Can anyone tell me why a report is not pulling the data from the hardware for a report? I have a BOM report setup and it pulls data from the hardware to cells in the report designer. It works for all hardware except the drawer slides. Hinges, plates, pulls etc. pulls the Hardware Code, Hardware Handling Code and Hardware Comments as shown in the attached, but it will not pull any info for drawer slides. Is there something I need to do different for this hardware?

    MVU eLearning



    Grow Your Knowledge
    Follow along with RJ as he takes you on a journey to build your foundational knowledge of Toolbox.


      Follow us on:

               

        Google Review