Placing a Sub Report on a Page in Report Designer

Placing a Sub Report on a Page in Report Designer

The articles in this section of the Knowledge Base involve working with Sub Reports for display in your reports. To learn more about Sub Reports, and how to access this section within the Report Designer, see Understanding Sub Reports in Report Designer. This article provides an overview of inserting a Sub Report on a page.

The Sub Report component cab be placed on any part of a page. The width of the nested page depends on the width of the Sub Report component. See Figure 01 for an example of the Sub Report component and nested page:


Fig. 01 – Sub Report Component and Nested Page

The Can Grow property of the Sub Report component is set to true by default but, when this component is placed, it cannot grow by height. So you should take into account the height of the component on the nested page: it should not be higher than the Sub Report component. When rendering a report, the Sub Report component is rendered as the report page item, the reporting tool renders all sub reports and places them in the container of the Sub Report component. Figure 02 features an example of placing the nested page in a report:


Fig. 02 – Sub Report and Sub Page
    • Related Articles

    • Understanding Sub Reports in Report Designer

      The articles in this section of the Knowledge Base involve working with the Sub Report component for display in your reports. To access the Report Designer, select Toolbox Setup > Design Reports > Design (Report Type) Report. Select New Report to ...
    • Placing a Sub Report on a Data Band in Report Designer

      The articles in this section of the Knowledge Base involve working with Sub Reports for display in your reports. To learn more about Sub Reports, and how to access this section within the Report Designer, see Understanding Sub Reports in Report ...
    • Working in the Sub Reports Editor of Report Designer

      The articles in this section of the Knowledge Base involve working with Sub Reports for display in your reports. To learn more about Sub Reports, and how to access this section within the Report Designer, see Understanding Sub Reports in Report ...
    • Tutorial: Creating a Report with a Sub Report in Report Designer

      The articles in this section of the Knowledge Base involve working with Sub Reports for display in your reports. To learn more about Sub Reports, and how to access this section within the Report Designer, see Understanding Sub Reports in Report ...
    • Creating Side-by-Side Reports with Sub Reports

      The articles in this section of the Knowledge Base involve working with Sub Reports for display in your reports. To learn more about Sub Reports, and how to access this section within the Report Designer, see Understanding Sub Reports in Report ...
    • Recent Articles

    • Toolbox Release Notes | Build 24.1.1105.641

      The following release notes apply to Toolbox build 24.1.1105.641 Nesting Fix Fig. 1: The fatal error that would occur during processing. There was reportedly an issue that occurred when clients attempted to process a work order using the nesting ...
    • Microvellum Foundation Library Release Notes | Build 24.1025

      The following release notes apply to Microvellum Foundation Library build 24.1025. Additions Added new global variable “Remove Stop Dado On Bottom Edge” for wood drawer boxes. Check this option to run the dado through at the bottom of the sub front ...
    • Toolbox Release Notes | Build 24.1.1030.641

      The following release notes apply to Toolbox build 24.1.1030.641 Routing and Profile Fixes Several issues were found with routing and polyline paths: Fig. 1: Horizontal routes off of a part disappearing (left) and appearing correctly (right). When ...
    • Toolbox Release Notes | Build 24.1.1010.641

      The following release notes apply to Toolbox build 24.1.1010.641 Biesse Winstore Fix Several issues with the Biesse Winstore plugin have been resolved: There was an issue that would sometimes occur wherein materials that were intended to stack wound ...
    • Toolbox Release Notes | Build 24.1.1001.641

      The following release notes apply to Toolbox build 24.1.1001.641 HBore Toolfile Fix Fig. 1: The location in the Toolfile UI where the error would occur. There was an issue reported with the functionality of the Horizontal Boring Machine setting in ...