IRIB Setmill Location Fix

Fig. 1: Setmill being moved to the start of the route (top) rather than at the center of a straight line, as intended (bottom).

1. There was an issue reportedly occurring during PTP operations, wherein parts would sometimes have their setmill moved to the incorrect position, appearing where the border route was starting rather than its set position. It was found that this issue was occurring when IRIB and “Remove Lead In/Out for DXF” were enabled simultaneously, with the two settings sometimes overwriting each other, resulting in the setmill location being erroneously registered as false within the software, and automatically setting the setmill at the starting point of the border route.  

1. This issue has been resolved. The fix has been applied to ensure that the setmill will be placed correctly during processing.