Issue: Part Label Prints an Extra Blank Label at the Beginning or End
Symptom
You have created a custom part label, but when you
print the labels, an extra blank label is printed at the beginning or end of
the series of labels.
Resolution 1
If the label contains group header bands, set the
GroupHeaderBand property "KeepGroupHeader" to False.
Resolution 2
Adjust the databand height property downward by
small increments until the blank page is eliminated. Be careful not to change
the height too much, or the label may print off-center.
Resolution 3
If the label contains a group header band, set the
GroupHeaderBand properties "New Page Before" and "New Page
After" both to False.
Recent Articles
Microvellum Foundation Library Release Notes | Build 24.0322
Additions Added the Master Angled Ends Cabinet. Added a Global prompt, "Hinge Plate Offset From Front" for easier control. Added “Double Division” option to Horizontal Designer Cabinets, 3 Door Cabinets, and other similar products. Added a new ...
Common Floating License Connectivity Issues
This document lists common issues reported by users regarding the topic of Microvellum’s Floating License Activation (FLA) and the connectivity required for FLA to function. Firewall Blocking Activation of Floating License Some users have had an ...
Toolbox Release Notes | Build 24.1.0318.641
The following release notes apply to Toolbox build 24.1.0318.641 Shadowline Fix Figure 1: Shadowline shaping issue (left) and fixed (right). There were reports of users experiencing issues with products having incorrectly shaped shadow lines when the ...
Toolbox Release Notes | Build 24.1.0312.641
The following release notes apply to Toolbox build 24.1.0312.641 Processing Station IDs Processing stations will have IDs added to them as an option within the Toolbox UI, to better distinguish between different processing stations. Perfect Graining ...
Toolbox Release Notes | Build 24.1.0306.641
The following release notes apply to Toolbox build 24.1.0306.641 Destroy Offal Fix Figure 1: Destroy Offal arc part issue. There was an issue reported by users utilizing nesting with the “Destroy Offal” setting applied during processing. ...