Assigning a Toolfile to a Processing Station

Assigning a Toolfile to a Processing Station

This article explains the steps to assign a toolfile to a processing station.

  1. Hover over "Toolbox Setup" and select "Options." 


  2. Select the "Processing Stations" tab and double click the processing station you would like to assign a toolfile to. 


  3. In the "Settings" tab, observe the toolfile section. Select "Edit" to edit the current toolfile or "Change" to assign a toolfile. 


  4. After assigning a toolfile, observe the toolfile column is updated with the assigned or edited toolfile.
    • Related Articles

    • Tutorial: Processing Stations Auto Assign Rules

      The "Auto Assign Rules" in the Processing Station settings are designed to save you time by automatically assigning Processing Stations to parts in the Processing Center based on the rules you select in the Processing Station Setup. This means you ...
    • Processing Station Associates for Reports

      For information about setting up part transformation functions required for builds 15.6.2404 through 21.1.0604, see Configuring Part Transformation Functions (Legacy Support). This article contains a detailed reference for setting up and using the ...
    • Configuration Editor: Processing Stations Options

      This article provides an overview of the options and settings available on the Processing Stations tab of the Configuration Editor (Options) Interface.  For a complete list of available tabs and options visit Overview: Configuration Editor (Options) ...
    • Parts File Processing Station Associates (Overview)

      Overview of Processing Station Parts File Associates Microvellum contains complete nesting optimizer and complete sawing optimizer solutions. It also supports third-party optimizers such as Ardis, BlueCell, and CutRite. Microvellum creates a “parts ...
    • Nesting Processing Station Controls and Settings

      To access the settings for a processing station, select the processing station and click the Edit icon. The Settings tab for the processing stations is the same across the different types of processing stations. Name – Allows you to set the name for ...
    • Recent Articles

    • Toolbox Release Notes | Build 24.1.1105.641

      The following release notes apply to Toolbox build 24.1.1105.641 Nesting Fix Fig. 1: The fatal error that would occur during processing. There was reportedly an issue that occurred when clients attempted to process a work order using the nesting ...
    • Microvellum Foundation Library Release Notes | Build 24.1025

      The following release notes apply to Microvellum Foundation Library build 24.1025. Additions Added new global variable “Remove Stop Dado On Bottom Edge” for wood drawer boxes. Check this option to run the dado through at the bottom of the sub front ...
    • Toolbox Release Notes | Build 24.1.1030.641

      The following release notes apply to Toolbox build 24.1.1030.641 Routing and Profile Fixes Several issues were found with routing and polyline paths: Fig. 1: Horizontal routes off of a part disappearing (left) and appearing correctly (right). When ...
    • Toolbox Release Notes | Build 24.1.1010.641

      The following release notes apply to Toolbox build 24.1.1010.641 Biesse Winstore Fix Several issues with the Biesse Winstore plugin have been resolved: There was an issue that would sometimes occur wherein materials that were intended to stack wound ...
    • Toolbox Release Notes | Build 24.1.1001.641

      The following release notes apply to Toolbox build 24.1.1001.641 HBore Toolfile Fix Fig. 1: The location in the Toolfile UI where the error would occur. There was an issue reported with the functionality of the Horizontal Boring Machine setting in ...